HFBoards (http://hfboards.hockeysfuture.com/index.php)
-   The Rink (http://hfboards.hockeysfuture.com/forumdisplay.php?f=150)
-   -   Blade for the S15 hockey shaft (http://hfboards.hockeysfuture.com/showthread.php?t=656507)

TheZherdev 06-29-2009 03:24 PM

Blade for the S15 hockey shaft
So I just got 2 new S15 hockey shafts delivered and put in two rbk 2k wood curves in them (Its also the first time I have bought rbk blades). Problem is the part that goes into the shaft is just a bit too skinny so that when I use it, I can feel the blade wiggling a little in the shaft. Its the same problem with both sticks with two different blades so I doubt the blade or the shaft is defective. Anyone have any clue why this is happening?

190Octane 06-29-2009 03:27 PM

Sometimes they can be off a little... if you're sure they are standard blades, try putting a strip of tape or two over them to get them to tighten up.

Hockeyfan68 06-29-2009 07:01 PM

Unfortunately the different companies do not offer exactly the same measurements for the hosel. Close but not quite ... may Bauer shafts fit bauer Blades perfectly and that is about all. The rest I have to put a strip of tape over the hosel piece and then I butter it up with hot glue from a hot glue stick.

that usually fixes it like the dude above this post said as well.

if your blade really wiggles I would bet that you bought Junior blades and are trying to use it in a standard shaft. A defensman on our team did that once and we all laughed at him .... hehe.

All times are GMT -5. The time now is 11:45 AM.

vBulletin Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
HFBoards.com, A property of CraveOnline, a division of AtomicOnline LLC ©2009 CraveOnline Media, LLC. All Rights Reserved.