View Single Post
Old
04-17-2008, 04:07 PM
  #18
stick9
Registered User
 
stick9's Avatar
 
Join Date: Aug 2004
Country: United States
Posts: 9,966
vCash: 500
Quote:
Originally Posted by FromChaos22 View Post
ok, sorry didn't understand that you were saying to put it in where the old blade was. All my one pieces aren't like that and the shaft actually gets thinner towards the blade, so if I were to put a new blade on, I would have to flip the stick upside down, and then the flex changes. Sorry!
In addition to MW's response. You can usually see the fuse point on an one piece after a few uses. It's not far from the blade itself. It's more noticeable on some sticks then others.

Here is a tapered shaft. They are thinner at the connection point and longer in length then a standard.

http://www.hockeymonkey.com/easton-s...igripsr06.html

Here is an example of a tapered blade. Notice how low the connection point.

http://www.hockeymonkey.com/easton-s...ent-blade.html

Using these two together is the same as an Easton Synergy one piece stick.

stick9 is offline   Reply With Quote