View Single Post
Old
03-14-2009, 11:44 PM
  #2
Hobgoblin Steve
Bacon of Light
 
Hobgoblin Steve's Avatar
 
Join Date: Feb 2009
Location: Bay Ridge
Country: Germany
Posts: 2,953
vCash: 500
I just did this with four Brooklynite sticks, Cut it with a hacksaw inch by inch until you could potentially fit a blade in there. you may have to go up 6 inches or so, so be prepared to use an end plug.
theres a picture of one of my new two pieces on the Brooklynite hockey thread.

keep in mind however, some shafts are rounded on the inside, so you may have to reshape the end part of a blade (hozel?). if your shaft is rounded, I recommend a wooden blade as it will be easier to work with.

Hobgoblin Steve is offline   Reply With Quote