View Single Post
Old
04-20-2009, 06:37 PM
  #14
playbedar
Registered User
 
playbedar's Avatar
 
Join Date: Nov 2008
Location: Granby, QC
Country: Canada
Posts: 828
vCash: 500
Send a message via MSN to playbedar
Quote:
Originally Posted by cptjeff View Post
You could try. The U+ is a monocomp stick, so it's going to be a lot harder. You'll need to saw it off very low at first and figure out what it'll take, and saw off small increments until it can fit a tapered blade. You may have to clean stuff out of inside the shaft, and in the end you may be hosed due to a weired shaft shape or something. But it is worth a shot IMO, especially if you have an old tapered blade lying around you can test it with so you don't have to buy a new one.
Well I think when it will break I'll by a tapered Warrior blade and if it can't fit on my CCM I'll just buy a Warrior shaft. That suck though because this CCM is pure gold, I hope it wont break too fast.

playbedar is offline   Reply With Quote