View Single Post
Old
05-28-2009, 05:16 PM
  #8
Saved*
 
Join Date: May 2008
Location: Canada
Country: Canada
Posts: 2,830
vCash: 500
Quote:
Originally Posted by Hockeyfan68 View Post
Hmmm what did you use for heat? Stove burner, flame torch, heat gun?

I wonder if a heat gun would get hot enough without making the blade too hot. How hot did you have to get it before it started to show signs of bending? I don't mean in degrees obviously but generally. very, not so very hot, etc?
I moved a torch over it for about 30 seconds each side, then put the blade on the ground and started opening the curve by pushing down. Brought it back up, continued and repeated until I had a 3/4ths curve that is open.

Saved* is offline   Reply With Quote