View Single Post
Old
06-11-2009, 10:06 PM
  #11
simnorm
Registered User
 
simnorm's Avatar
 
Join Date: Aug 2005
Posts: 108
vCash: 500
I have a dolomite ops that was cut at the fuse point. I use heat, a short rebar and a hammer to knock what was left of the tenon back into the shaft. Since it's tapered, the tenon came loose and fell down the shaft, coming out at the buttend.

I tried the same thing with a Vapor XX, didn't work. I had to use heat and chisel out the tenon.

good luck.

simnorm is offline   Reply With Quote