Thread: Shaft Question
View Single Post
Old
01-07-2010, 03:12 PM
  #20
stick9
Registered User
 
stick9's Avatar
 
Join Date: Aug 2004
Country: United States
Posts: 9,957
vCash: 500
Quote:
Originally Posted by thedoc1019 View Post
the way this whole topic came about was because my current blade feels loose inside my aluminum shaft and I thought that would be because of this tapered or non-tapered stuff but now that I've figured out that my blade and my shaft are both standard I would like to know if any of you know why my blade is loose.After a slap shot I notice that if I push down on the blade it pops it back into place by a centimeter and also if I were to pick up the stick and shake it I'm able to feel the blade shaking around like its loose.I looked at the blade and it looks like its in all the way but if I pull on it it pops out a centimeter and then I have to pop it back in.

Does anyone know how to fix this?

Ohh by the way I have a RBK 5K blade
This is common and very easy to fix. Remove the blade, put a strip of tape over the end you insert into the shaft, add some glue...some heat and put the blade back in. If you did it right, it should be a nice snug fit. If you did it wrong the tape comes off and you left with a glue covered mess.

stick9 is offline   Reply With Quote