View Single Post
Old
11-05-2011, 06:29 PM
  #4
chickennecker
Registered User
 
Join Date: Jul 2011
Posts: 12
vCash: 500
My first stick was a octogun and broke probably the same spot. A tapered blade with fit fine in the bottom probably will have to use an ext in the top for lenght. Its super easy, cut the break clean, heat stick andand tenon of bladethe with blowdryer(stick should be hot and tenon glue soft) and put in the tapered blade. If it doesn't fit, just make a new cut about 1/8- 1/4inch above andheat and try again. Also, I mask both the stick and blade so when the glue dries it easily comes off.

Fyi- I used a warrior dd tapered blade, which imo, has a thinner tenon. That stick now has a easton wood blade in it, for use on concrete, and I cut a little bit extra off the stick to make that tenon fit.

chickennecker is offline   Reply With Quote