View Single Post
Old
07-04-2006, 10:43 AM
  #10
Bob Clarke Fan Club
Registered User
 
Bob Clarke Fan Club's Avatar
 
Join Date: Feb 2003
Country: Canada
Posts: 5,002
vCash: 500
It's probably the holder and yes, they can be removed with a rivet machine. Just use silicone to cover any old holes. I'm assuming they're new skates so it shouldn't have anything to do with blade height, contour etc...
also, put a coin on your blades after you get them sharpened to make sure your edges aren't off. There's plenty of new sharpener holders that if not used correctly can leave you with high edges on the outside...although this is probably not the problem it's a good way to actually see the hollow cut out. Don't do it in front of the sharpener though...Some of these guys offend easily.

Bob Clarke Fan Club is offline   Reply With Quote