View Single Post
Old
07-04-2006, 09:49 PM
  #1
RangersMoogle
Registered User
 
Join Date: Oct 2005
Location: Ohio
Country: American Samoa
Posts: 966
vCash: 500
Send a message via AIM to RangersMoogle Send a message via MSN to RangersMoogle
For ya all with broken one piece Synergy Blades.

I was feeling ambitious, so I finally decided to bust out the digital camera to take some pictures of where to chop the blade off.

Contrary to what I've read, you don't have to cut it off between the "PAT" and "PENDING", I cut between the 'D' and the 'I', and had about half an inch of hollow tube left from the blade side. I'm only holding a small piece because it took some trial and error to get it right.

I had a hecka hard time finding any info about cutting my Synergy, hopefully this helps some of ya all.

RangersMoogle is offline   Reply With Quote