View Single Post
10-27-2006, 11:15 PM
Registered User
Join Date: Jan 2005
Country: Haiti
Posts: 141
vCash: 500
Totally understandable. But for skates, the user in question doesn't have to program it, it's on the chip.

Much more easier than contouring by hand, and less skill required to operate.

While it does the job, the general consensus in the business is that you will do a better job manually than with a CAG. There is human finesse involved in sharpening/contouring, and unfortunately, it can result in human failure.

The guy's good, don't get me wrong, but not the "end all to be all" guy out there as he proclaims on his site.

ModSquad is offline   Reply With Quote