View Single Post
07-12-2013, 01:53 PM
Registered User
Join Date: Jun 2010
Posts: 147
vCash: 500
Most people don't think much about the physics of it all, so they just go and have skates sharpened. So, in general, a shop will have a typical "house" radius that they keep on the grinding wheel unless there is a request for something else. I think most of the time it's 1/2" but sometimes it's 5/8".

Then there is also the fact that some shops are better than others about keeping the wheel dressed properly so that the radius is accurate.

McDugan is offline   Reply With Quote