View Single Post
Old
11-25-2013, 03:14 PM
  #24
sanityplease
Registered User
 
sanityplease's Avatar
 
Join Date: Jun 2011
Country: Canada
Posts: 1,095
vCash: 500
Uneven edges are unskatable, even dangerous. I had a botch job done a month ago or so. Edges were so uneven, it was obvious just looking @ them, & very obvious skating on them. I put a steel straight edge across them so that both points were touching, it was at about a 20 degree angle.... Took them to another sharpener who isn't very good (had to it was an emergency), they used a gauge, & said that they looked pretty good & didn't see a problem...

sanityplease is offline   Reply With Quote